Beck Arnley 086-1897C Ceramic Brake Pad

This time I cleaned the carbon off the tops of the pistons (doh I know…) and found a great big crack across no. 3 that was not originally visible under the carbon:. The other pistons weren’t great and were showing signs of similar wear so I bought a new set of AE from Dunsfold for £100 and installed them with new big end shells. I thought it must be worn valve stem seals or a badly worn valve guide on no. 3 cylinder due to that plug being so oiled up. The engine was also now starting to miss on no. 3 due to the contamination of the spark plug. I managed to replace the valve guides by using the drifts sold by Dingocroft (these are copies of Landrover special tools RO274400 for the inlet, can’t find the part number for the exhaust guide drift). Lots of head scratching ensued…so head off again. 25 petrol engine, I had a problem with excessive blue smoke, mainly after the engine had been idling for any amount of time.

The Triumph street bike was modified to work with the XCOR rocket piston pump technology and subsequently shipped to Motion Performance in Roswell, where XCOR engineers finished modifying and testing the bike for the trials. "We debated how best to put many hours of wear time on the critical bearing components of our rocket propellant piston pump, that are subject to significant wear and tear," said Dan DeLong, XCOR Chief Engineer. Naturally riding a motorcycle through some of the most stunning country in the U. S. while on a Triumph street bike and saving the company so much money, they probably let them spend a little of it. Nice work if you can get it. "We saw some... After admirable presentations at nearby schools as part of XCOR's ongoing Science, Technology, Engineering and Mathematics (STEM) educational outreach, the Truimph “rocket-bike” and the XCOR team were given a send-off by Roswell Mayor Del Jurney... "We put twenty hours – the equivalent of 400 Lynx flights – on the rocket pump bearings by driving from Roswell to Mojave taking periodic data readings along the way to make sure things were in good condition," Dan stated. "XCOR continues to solidify its reputation as an innovative, nimble company when it comes to research and development practices," commented XCOR Chief Operating Officer, Andrew Nelson. Of course, where better to test out a part for a spacecraft than the place known for interplanetary travel for over 60 years – Roswell NM. Take it out on the former subject of prose, poetry and song – Route 66, the pre-Interstate route of choice...